Marshall Roofers
A new flat roof being laid on a brick extension above a garden

Flat Roofs

Flat Roofs in Berkshire, Surrey and West London

New and replacement flat roofs on extensions, garages, dormers and porches, laid to fall so water actually leaves.

Get a price for flat roofs

Send your details and a short description of the job.

7am to 7pm, seven days

14 towns covered

Emergency call-outs

Priced in writing

The work

A flat roof is not actually flat

A flat roof is not actually flat. It needs a fall of around 1 in 80 so rainwater runs to the outlet instead of sitting in a pool. We strip the failed covering, check and replace any soft decking, correct the fall with new firrings, and re-cover in GRP fibreglass, EPDM rubber or torch-on felt to suit the roof. Extensions, garages, dormers and porches are the usual jobs.

Getting the fall and the detailing right means the roof drains properly and stays watertight for the long term, not just until the next heavy downpour. A warm-roof build-up with upgraded insulation also makes the room underneath warmer and cheaper to heat.

Where an old roof has ponded we correct the firrings underneath rather than covering the problem over, and we talk you through which covering makes sense for your roof and your budget. The price is itemised and the site is left clean.

A finished grey GRP flat roof with a glazed lantern rooflight set into it

What you get

What is included

  • 1

    Strip and check the deck

    Strip the failed covering and check the deck underneath

  • 2

    Replace soft decking

    Replace soft or delaminated decking boards

  • 3

    Correct the fall

    New firrings where the fall needs correcting

  • 4

    Upgrade the insulation

    Insulation upgraded to current standards on a warm roof build-up

  • 5

    The right covering

    GRP fibreglass, EPDM rubber or torch-on felt, whichever suits the roof

  • 6

    New edges and outlets

    New drip trims, edge detail and outlet connections

The process

How flat roofs normally runs

  1. 01

    Survey the roof

    Checking the fall, the outlet, the deck condition and where water has been sitting.

  2. 02

    Recommend a covering

    GRP, EPDM or felt, with the reason for the recommendation rather than a default.

  3. 03

    Strip and repair the deck

    Soft boards come out, firrings go in where the fall needs correcting.

  4. 04

    Lay the covering

    Trims and outlet detail first, then the membrane, finished in one visit where the weather holds.

Pricing

What moves the price

Every roof is different, so the quote follows a look at yours rather than a figure over the phone. The roof, and the loft where the fault is a leak, both get checked before anything is priced.

The quote you get back is itemised: access, materials, labour and clearing the site. Where the job needs scaffold, that goes in the figure from the start, not added later. The points on the right are what make the biggest difference to where the price lands.

What we look at

  • The area of the roof and how much of the deck needs replacing
  • Which covering you go with
  • Whether the fall needs correcting with new firrings
  • Insulation, if the roof is being brought up to a warm roof build-up
  • Access, and whether the roof can be reached from ground level

Coverage

Where we carry out flat roofs

Across Berkshire, Surrey and West London, including Reading, Wokingham, Bracknell, Maidenhead, Windsor, Staines-upon-Thames, Feltham, Kingston upon Thames, Richmond, Surbiton, Epsom, Walton-on-Thames, Camberley and Twickenham.

  • Reading
  • Wokingham
  • Bracknell
  • Maidenhead
  • Windsor
  • Staines-upon-Thames
  • Feltham
  • Kingston upon Thames
  • Richmond
  • Surbiton
  • Epsom
  • Walton-on-Thames
  • Camberley
  • Twickenham

Calls answered 7am to 7pm, seven days a week

See every area we cover

FAQs

Things people ask about flat roofs

How long does a flat roof last?

It depends on the covering and how well the roof drains. A well laid GRP or EPDM roof on a correct fall lasts considerably longer than felt, and a roof that ponds will fail early whatever is on it.

Can you go over the top of the old covering?

We would not recommend it. Overlaying hides a wet or soft deck and keeps whatever fall problem caused the failure, so the new covering tends to go the same way.

Which is better, GRP or EPDM?

GRP gives a hard, seamless finish and suits roofs with a lot of detail and trim. EPDM is a single rubber sheet with very few joins and handles movement well on larger, simpler roofs. The survey decides which fits your roof.

Free quote

Get Your Quote

Fill out the form below and we will get back to you quickly.

Get a price for flat roofs

A photo and a postcode is usually enough to get started.

Call nowGet a quote